W5100 Ethernet Shield


Only 1 left in stock

Operating voltage:  5V (supplied from the Arduino Board)
Ethernet Controller: W5100 with internal 16K buffer
Connection speed: 10/100Mb
Interface Type: SPI

480.00 599.00 "inc. GST"

Only 1 left in stock

The Arduino Ethernet Shield W5100 connects your Arduino to the internet in mere minutes. Just plug this module onto your Arduino board, connect it to your network with an RJ45 cable (not included) and follow a few simple instructions to start controlling your world through the internet. As always with Arduino, every element of the platform – hardware, software and documentation – is freely available and open-source. This means you can learn exactly how it’s made and use its design as the starting point for your own circuits.

The Shield  contains a number of informational LEDs

PWR: indicates that the board and shield are powered

LINK: indicates the presence of a network link and flashes when the shield transmits or receives data

FULLD: indicates that the network connection is full duplex

100M: indicates the presence of a 100 Mb/s network connection (as opposed to 10 Mb/s)

RX: flashes when the shield receives data

TX: flashes when the shield sends data

TX: flashes when the shield sends data

COLL: flashes when network collisions are detected

How to use:

Features of Arduino Ethernet Shield W5100:

  • IEEE 802.3af compliant.
  • Low output ripple and noise (100 mV pp.)
  • Input voltage range 36V to 57V.
  • Overload and short-circuit protection.
  • 9V Output.
  • High efficiency DC/DC converter: typ 75% @ 50% load.
  • 1500V isolation (input to output).

Applications of Arduino Ethernet Shield W5100:

  • Layer 2 VPNs for IT Infrastructure.
  • Cloud Computing.
  • Site to Site Access.
  • Software-as-a-Service (SaaS).
  • Distributed Storage Area Networks.
  • Business Continuity/Disaster Recovery

Based on 0 reviews

0.0 overall

Be the first to review “W5100 Ethernet Shield”

There are no reviews yet.

You may also like…