-60%
,

RAMPS Board 1.4 Arduino Mega Shield

Availability:

In stock


Supply Voltage: 12V
Standard interfaces (as that of the extruder)
Reserved GCI like I2C and RS232
3 MOSFET’s are applied to the heater/ fan and thermistor circuit.
Another 5A added to protect the component parts.
An 11A fuse is added to the hotbed.
Support 5 stepper drive board

320.00 799.00 "inc. GST"

In stock

This is Mega Pololu Shield or RAMPS for short. The 3D Printer Controller Board RAMPS 1.4 is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform and has plenty of room for expansion.

RAMPS can only work when connected to its motherboard Mega 2560 and A4988/DRV8825. Owning to its stability in operation and great compatibility with the most 3D printer (all RepRap-model such as Prusa i2 and i3). The combination of Ramps1.4 + MEGA2560 + A4988/DRV8825is becoming a mainstream of DIY 3D printer control board.

The modular design includes the plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability, and expansion. Additionally, a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “RAMPS Board 1.4 Arduino Mega Shield”

There are no reviews yet.

SHOPPING CART

close